Commands Listed in Alphabetical Order
D<x>:LABel
This command specifies the waveform label for digital channel <x>, where x
is the channel number.
Conditions
Requires an MSO or MDO4000/B/C model, or MDO3000 with option
MDO3MSO installed.
Group
Vertical
Syntax
D<x>:LABel <Qstring>
D<x>:LABel?
Arguments
<Qstring> is an alphanumeric string of text, enclosed in quotes, that contains the
text label information for the digital channel <x> waveform. The text string is
limited to 30 characters.
Examples
D4:LABEL? might return :D4:LABEL “Clk Wfm 4”.
D<x>:POSition
This command specifies the vertical position for digital channel <x>, wherex
is the channel number.
NOTE. Unlike analog channels, which use the center baseline as the zero point,
digital channels use the bottom logic level as the zero point. Because of the slot
model used to describe digital channel position, the oscilloscope rounds off
divisions to the nearest slot.
Conditions
Requires an MSO or MDO4000/B/C model, or MDO3000 with option
MDO3MSO installed.
Group
Vertical
Syntax
D<x>:POSition <NR3>
D<x>:POSition?
2-302 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
