Commands Listed in Alphabetical Order
Arguments
OFF or <NR1> = 0 r
emoves the message window from the screen.
ON or <NR1> ≠ 0 displays the message window and its contents on the screen.
NEWpass (No Query Form)
This command changes the password that enables access to password protected
data. The PASSWord command must be successfully executed before using this
command or an execution error will be generated.
Group
Miscellaneous
Syntax
NEWpass <QString>
Related Commands
*PUD
PASSWord
Arguments
<QString> is the new password, which can contain up to 16 characters.
Examples
NEWPASS "mypassword" creates a new password (mypassword) for accessing
your protected data.
*OPC
Generates the Operation Complete message in the Standard Event Status Register
(SESR) when all pending commands that generate an OPC message are complete.
The *OPC command allows you to synchronize the operation of the oscilloscope
with your application program. Examples of this commands usage are
available(See page 3-7, Synchronization Methods.) The *OPC? query places
the ASCII character "1" into the output queue when all such OPC commands
are complete.
The *OPC? response is not available to read until all pending operations finish.
(See page 3-978, Status and Events.)
Certain oscilloscope operations can affect the
*OPC response. (See Table 3-3
on page 3-8.)
Group
Status and Error
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-457
To Next Page
Loading...
Need help?
General
