Commands Listed in Alphabetical Order
SELect:RF_NO
RMal
This command switches the frequency domain Normal trace display on or off in
the frequency domain graticule.
Conditions
MDO3000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
RF
Syntax
SELect:RF_NORMal {OFF|ON|0|1}
SELect:RF_NORMal?
Arguments
OFF or 0 turns the frequency domain Normal trace display off.
ON or 1 turns it on.
SELect:RF_PHASe
This command switches the RF Phase vs. Time trace display on or off in the
time domain graticule.
Conditions
MDO4000/B/C models only.
Group
RF
Syntax
SELect:RF_PHASe {OFF|ON|0|1}
SELect:RF_PHASe?
Arguments
OFF or 0 turns the RF Phase vs. Time trace display off.
ON or 1 turns it on.
SET? (Query Only)
Returns the commands that list the oscilloscope settings except for configuration
information for the calibration values, the WFMInpre? qu
ery, and the
WFMOutpre? query. This query allows you to record or "learn" the current
oscilloscope settings. You can use these commands to return the oscilloscope to
the state it was in when you made the SET? query. The SET? query always returns
command headers, regardless of the setting of the HEADer|:HDR command. This
is because the returned commands are intended to be sent back to the oscilloscope
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-761
To Next Page
Loading...
Need help?
General
