Tektronix TBS1032B User Manual

Time Cursors. Time cursors appear as vertical lines on the display and measure
both horizontal and vertical parameters. Times are referenced to the trigger point.
For the FFT function, these cursors measure frequency.
Time cursors also include a readout of the waveform amplitude at the point the
waveform crosses the cursor.
Automatic
The Measure Menu can take up to six automatic measurements. When you take
automatic measurements, the oscilloscope does all the calculating for you.
Because the measurements use the waveform record points, they are more
accurate than the graticule or cursor measurements.
Automatic measurements use readouts to show measurement results. These
readouts are updated periodically as the oscilloscope acquires new data.
For measurement descriptions, refer to the Reference chapter. See Measure on
page 91.
Understanding oscilloscope functions
TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual 27

Tektronix TBS1032B Specifications

General

Bandwidth	30 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5 kpts
Timebase Range	5 ns/div to 50 s/div
Display Resolution	800 x 480
Connectivity	USB 2.0
Input Coupling	AC, DC, GND
Interface	USB
Power Supply	100-240 VAC, 50/60 Hz
Display	7 inch TFT color display
Vertical Sensitivity	2 mV/div to 5 V/div
Trigger Types	Edge, Pulse, Video
Math Functions	Add, Subtract, Multiply, Divide
Input Impedance	1 MΩ ± 2%
Maximum Input Voltage	300 V (DC + peak AC)
Probe Type	Passive