Tektronix TBS1032B User Manual

Taking automatic
measurements
The oscilloscope can take automatic measurements of most displayed signals.
NOTE. If a question mark (?) appears in the Value readout, the signal is outside
the measurement range. Adjust the Vertical Scale knob (volts/division) of the
appropriate channel to decrease the sensitivity or change the horizontal Scale
setting (seconds/division).
To measure signal frequency, period, and peak-to-peak amplitude, rise time, and
positive width, follow these steps:
1. Push the Measure button to see the Measure Menu.
2. Push the channel 1 or the 2 button. The measure menu appears to the left.
3. Turn the Multipurpose knob to highlight the desired measurement. Push the
knob to select the desired measurement. .
The Value readout displays the measurement and updates.
4. Push the channel 1 or 2 button to select another measurement. You can
display up to six measurements on the screen at a time.
Measurem
ents
Period
Frequency
Peak-Peak
Minimum
Maximum
Mean
Cycle
Mean
Cursor
Mean
RMS
Cycle RMS
Cycle RMS
Rise Time
Measure
Gating
On / Off
Ch1
Ch2
Math
Application examples
TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual 31

Tektronix TBS1032B Specifications

General

Bandwidth	30 MHz
Channels	2
Sample Rate	1 GS/s
Record Length	2.5 kpts
Timebase Range	5 ns/div to 50 s/div
Display Resolution	800 x 480
Connectivity	USB 2.0
Input Coupling	AC, DC, GND
Interface	USB
Power Supply	100-240 VAC, 50/60 Hz
Display	7 inch TFT color display
Vertical Sensitivity	2 mV/div to 5 V/div
Trigger Types	Edge, Pulse, Video
Math Functions	Add, Subtract, Multiply, Divide
Input Impedance	1 MΩ ± 2%
Maximum Input Voltage	300 V (DC + peak AC)
Probe Type	Passive