Function
For non-EDU models, use the Function button to access: limit test, data logging,
the counter, and the trend plot.
For EDU models, use the Function button to access the counter.
Non-EDU models
Options Settings Comments
Limit Test Source Defines the source of the waveforms against
which to run the template waveform
Compare To Specifies the limit test template against which to
compare the signals defined with the Source
menu item.
Run/Stop Test Toggles between whether to start or stop the
limit test
Template Setup Sets up a limit test waveform template. This is
the mask signal you define as the boundary to
compare with the input source signal. Do this
before running a limit test
Action on Violation Defines the actions the oscilloscope will take
after detecting a violation
Stop After Defines the conditions that will cause the
oscilloscope to end limit testing
Data Logging Data Logging Sets the data logging feature on or off
Source Sets the signal source to log data from
Duration Sets the time duration of data logging in half
hour increments, from 0.5 hour to 8 hours, or in
one hour increments, from 8 hours to 24 hours,
or to indefinite
Select Folder Sets the folder to save the waveform data to
Counter Ch1, Ch2, Ch1 Trigger,
Ch2 Trigger
Trend plot Run/Stop, Source 1,
Type 1, Source 2, Type
2
Plot a graph of one or two measurements as a
function of time.
Reference
88 TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
