Saving Waveforms and Setups
3–180
TDS 500D, TDS 600B, & TDS 700D User Manual
The oscilloscope determines if a printer or Zip drive is attached at power up.
Changing, and then attempting to use, the I/O device after power-up will
generate an error message.
See Saving and Recalling Setups, on page 3–165.
See Saving and Recalling Waveforms and Acquisitions, on page 3–168.
See Printing a Hardcopy, on page 3–180.
Printing a Hardcopy
The TDS Oscilloscope can provide you with hardcopies of its display. To obtain
a hardcopy, you need to know how to configure the communication and
hardcopy parameters of the oscilloscope, how to connect it to one of the many
hardcopy devices it supports, and how to print the hardcopy. This subsection
describes how to do these tasks and how to save a hardcopy to a disk.
To Find More Information
To Next Page
Loading...
Need help?
General
