Tektronix TDS2002 Programmer's Manual

TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−15
Command Groups
This section lists the commands organized by functional group. The
Command Descriptions section, starting on page 2-35, lists all
commands alphabetically.
The oscilloscope GPIB and RS-232 interfaces conform to Tektronix
standard codes and formats except where noted. The GPIB interface
also conforms to IEEE Std 488.2–1987 except where noted.
Acquisition Commands
Acquisition commands affect the acquisition of waveforms. These
commands control mode, averaging, and single-waveform
acquisition. Table 2-7 lists and describes Acquisition commands.
Table 2−7: Acquisition commands
Header Description
ACQuire? Return acquisition parameters
ACQuire:MODe Set/query acquisition mode
ACQuire:NUMACq? Return # of acquisitions obtained
ACQuire:NUMAVg Set/query number of acquisitions for
average
ACQuire:STATE Start or stop acquisition system
ACQuire:STOPAfter Set/query acquisition control
Calibration and Diagnostic Commands
Calibration and Diagnostic commands let you initiate the oscillo-
scope self-calibration routines and examine the results of diagnostic
tests. Table 2-8 lists and describes Calibration and Diagnostic
commands.

Tektronix TDS2002 Specifications

General

Brand	Tektronix
Model	TDS2002
Category	Test Equipment
Language	English