TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−35
Command Descriptions
Commands either set or query oscilloscope values. Some commands
both set and query, some only set, and some only query.
Manual Conventions
This manual uses the following conventions:
H No Query Form indicates set-only commands
H A question mark (?) appended to the command and Query Only
indicates query-only commands
H Fully spells out headers, mnemonics, and arguments with the
minimal spelling shown in upper case; for example, to use the
abbreviated form of the ACQuire:MODe command, just type
ACQ:MOD
H Syntax of some commands varies, depending on the model of
oscilloscope and extension module you are using; differences are
noted
NOTE. While Trigger View is active (when you push the TRIG VIEW
button on the front panel), the oscilloscope ignores the set form of
most commands. If you send a command at this time, the oscilloscope
generates execution error 221 (Settings conflict).
ACQuire? (Query Only)
Returns all the current acquisition parameters.
Acquistion
ACQuire?
Group
Syntax
To Next Page
Loading...
Need help?
General
