Reference
96
TDS1000/2000-Series Digital Oscilloscope User Manual
Print
Push the PRINT button to send the screen da ta to a printer or
computer.
The print function requires the optional TDS2CMA Communications
Extension Module. The module includes Centronics, RS-232, and
GPIB ports.
Refer to the TDS2CMA Communications Module chapter on
page 127 for complete operating information. Refer to Optional
Accessories on page 169 for ordering information.
Probe Check
You can use the Probe Check Wizard to quickly verify that your
probe is operating properly.
To use the Probe Check Wizard, push the PROBE CHECK button. If
your probe is connected properly, compensated properly, a n d the
Probe entry in the oscilloscope VERTICAL menu is set to match
your probe, the oscilloscope will display a PASSED message at the
bottom of the screen. Otherwise, the oscilloscope will display
directions on the screen to guide you in correcting these problems.
To Next Page
Loading...
Need help?
General
