Compliance information
United Kingdom
1
This product is intended for use in nonresidential areas only. Use in residential areas
may cause electromagnetic interference.
2
Emissions which exceed the levels required by this standard may occur when this
equipment is connected to a test object.
3
For compliance with the EMC sta nd
ards listed here, high quality shielded interface
cables should be used.
4
The increase in trace noise while subjected to a test field (3 V/m over the frequency
range 80 MHz to 1 GHz, 1.4 GHz to 2.0 GHZ and 1 V/m from 2.0 GHz to 2.7 GHz, with
80% amplitude modulation at 1 k
Hz) is not to exceed 3 major divisions peak-to-peak
at 5 mV/div and higher.l
5
The increase in trace noise while subjected to a test field (3 V/rms over the frequency
range 150 kHz to 80 MHz, with 80% amplitude modulation at 1 kHz) is not to exceed 2
major divisions peak-to-pe a
k at 5 mV/div and h igher.
6
Performance C riterion C applied at the 70%/25 cycle Voltage-Dip and the 0%/250 cycle
Voltage-Interruption test levels (IEC 61000-4-11).
Australia / New Zealand De
claration of Conformity – EMC
Complies with the EMC provision of the Radiocommunications Act per
the f ollowing standard,
in accordance with ACMA:
CISPR 11:2003. Radiated an d Conducted Em issio ns, Group
1, Class A , in accorda
nce with EN 61326-1:2006 and
EN 613 26-2-1:2 006 .
Australia / New Zealand contact.
Baker & McKenzie
Level 27, AMP Centre
50 Bridge Street
Sydney NSW 2000, A ustralia
FCC – EMC
Exempt from FCC 47 CFR Part 15, Subpart B, Class A
xii TDS3000C Series Oscilloscope User Manual
To Next Page
Loading...
Need help?
General
