Tektronix TDS3034B Reference

42
Configuring Your Oscilloscope Ethernet Settings
Before using the e*Scope feature, you must set your
oscilloscope Ethernet network settings. The TDS3000B
Series Digital Phosphor Oscilloscope User Manual,
Appendix G, Ethernet Setup, describes how to enter the
Ethernet network parameters for your oscilloscope.
Accessing e*Scope
After your instrument is set up with the correct ethernet
settings, you are ready to access that instrument over the
Internet. To access you instrument’s e*Scope server, do
the following steps:
1 On a PC or work station, open a network browser
program.
2 In the Location or Address field (where you normally
enter a URL), type in the IP address of the
TDS3000B instrument to which you want to connect.
For example, 188.121.212.107. Do not precede the IP
address with any characters. Then press the Return
key.
3 The browser program loads the instrument’s e*Scope
Web-based Remote Control home page, which is an
image of the screen contents when your browser
accessed the instrument.
41
e*Scope Web-based Remote Control
e*Scope introduces the next generation of oscilloscope
functionality. With e*Scope you can access any Internet-
connected TDS3000B Series oscilloscope from a
browser on your work station, PC, or laptop computer.
No matter where you are, your TDS3000B is as close as
the nearest browser!
There are two levels to e*Scope: basic and advanced.
The basic level, which is hosted on the oscilloscope, lets
you view a screen image of the current acquisition, save
or load waveform and setup files, and remotely control
the oscilloscope using the oscilloscope programming
commands.
The advanced level, which is hosted on your system,
provides a graphical user interface to remotely control
the oscilloscope. To obtain the advanced level software,
go to the Tektronix TDS3000B website and download
the web-based remote control software.
NOTE. You can also use e*Scope on TDS3000
Series oscilloscopes that are equipped with a
TDS3EM Ethernet communication module and
are running firmware version 3 or above.

Tektronix TDS3034B Specifications

General

Brand	Tektronix
Model	TDS3034B
Category	Test Equipment
Language	English