Basic Installation
This chapter describes all of the steps needed to install your Tektronix logic
analyzer and its related accessories.
Check the Shipping List
Check that you have received all of the parts of your logic analyzer using the
shipping list. Also check the following:
That you have the correct power cords for your geographical area.
That you have backup copies of the installed software. Store the backup
software in a safe location w here you can easily retrieve the software for
maintenance purposes.
That you have all the standard and optional accessories that you ordered.
Fill out and return the customer registration card that is packaged with this manual.
Environmental Considerations
Read this section before installing the logic analyzer. This section describes
site considerations, power requirements, and ground connections for your logic
analyzer.
CAUTION. Allow a 5.1 cm (2 in) clearance around the top, back, and sides of
the inst
rument to ensure proper cooling. Inadequate clearances can cause the
instrument to overheat and shut down.
You can use the logic analyzer on a bench or on a cart in the normal position (on
the bottom feet).
Chassi
s Ground Connections
Use the chassis ground connections to connect the grounds of the target system
(system-under-test) to the logic analyzer to ensure a common ground connection
betwe
en instruments. (See Figure 1.)
TLA5000 Series Logic Analyzer Installation M anual 1
To Next Page
Loading...
Need help?
General
