Tektronix TriMode P7700 Series User Manual

Thread tip onto wires. The two
middle vias are the A(+) and B(-)
inputs of the tip.
You may find it useful to use the
double-sided foam tape that was
shipped with your probe to hold
the probe tip in place.
With the tip in position, quickly
solder the wires to the vias. If the
soldering iron is left too long on
the tip, it may cause the
0201 input resistors to reflow and
move.
Trim wires flush with the board
on the probe tip.
Basic operation
P7700 Series TriMode™ Probes 31

Tektronix TriMode P7700 Series Specifications

General

Brand	Tektronix
Model	TriMode P7700 Series
Category	Measuring Instruments
Language	English