Teldat Router User Manual

3. Configuring the UMTS Interface
The UMTS interface as such is an AT commands interface
There are certain commands which are common for all the device’s interfaces. These commands are
described in the manual on configuring common interfaces (Dm 772-I Common Configurations for
Interfaces).
The available programming commands are as follows:
Command Functions
? (HELP) Lists the available commands or their options.
ADDITIONAL-CONTROL-COMMAND Configures the connectivity control.
ALWAYS-ATTACHED Controls the module attach/detach to the network.
DISABLE Disables functionalities.
ENABLE Enables functionalities.
FRAME-SIZE Configures the base interface frame size.
NO Permits you to configure default values or negate a
command.
PIN Programs the PIN number for the SIM module used.
SPEED Programs the interface speed.
UMTS Permits you to configure UMTS connection
parameters.
WAIT-TIME Configures the physical connection maximum wait
time.
EXIT Returns to the configuration menu.
3.1. ? (HELP)
Displays a list of the available commands or their options.
Syntax:
umts2/0 AT config>?
Example:
umts2/0 AT config>?
accessibility-control Set GPRS accessibility control
always-attached In PDP context disconnection not perform detach
disable Disable some features
enable Enable some features
frame-size Set frame size
no Set default config
pin Set PIN number for internal Module
speed Set speed
umts UMTS configuration
wait-time Set maximum connection time
exit Return to previous menu
umts2/0 AT config>
TELDAT ROUTER– UMTS Configuration
II - 11
Doc.DM757-I
Rev.10.60

Teldat Router Specifications

General

Brand	Teldat
Model	Router
Category	Network Router
Language	English