2. PCMCIA Monitoring Commands
This section describes the commands used to monitor the PCMCIA interface state at the physical layer
(controller and card).
Normally these do not provide operating information, however they can be useful when detecting
problems in the PCMCIA card installation, when the card is defective for example.
Access the commands from the p3 menu by using the system pcmcia command:
*p 3
+
Command Function
DEBUG Enables or disables debugging traces (p 2) over the PCMCIA controller.
DUMP Displays information from the controller and the card.
2.1. SYSTEM PCMCIA DEBUG
Enables or disables the PCMCIA events debugging traces.
Enable:
+system pcmcia debug enable
PCMCIA debug enabled
Disable:
+system pcmcia debug disable
PCMCIA debug disabled
Example:
Traces detected in the insertion where a PCMICA UMTS card has been correctly detected, is shown
below:
12/28/04 12:26:47 i82365: socket event 0x0080
12/28/04 12:26:47 i82365: socket event 0x0080
12/28/04 12:26:48 cs: setup_socket(0): applying power
12/28/04 12:26:52 cs: resetting socket 0
12/28/04 12:26:53 cs: reset end socket 0
12/28/04 12:26:56 cs: reset done on socket 0
12/28/04 12:26:56 cdrmngr: do_insert 0
12/28/04 12:26:56 Socket 0: Novatel Wireless Merlin UMTS Modem NRM6831 PC Card
12/28/04 12:26:56 Card product info: [Novatel Wireless], [Merlin UMTS Modem],
[NRM6831], []
12/28/04 12:26:56 Card manfid: 0x00a4, 0x1aaf
12/28/04 12:26:56 Card function: 2 [serial]
12/28/04 12:26:56 serial_attach()
12/28/04 12:26:56 serial_event(0x01010810): (0x000004)-> card insertion
12/28/04 12:26:56 serial_config(0x01010810)
12/28/04 12:26:56 rscmng: register base:0x3f8 num:0x8 owner:serial_cs
12/28/04 12:26:56 serial_cs: register_serial() at 0xf20003f8,irq 34 slot 2 line 0
success
12/28/04 12:26:56 serial_attach() success on 0x01010810
12/28/04 12:26:56 cdrmngr: do_insert 0 success
12/28/04 12:26:57 uart_speed at 460800 (0x6)
TELDAT ROUTER– UMTS Monitoring
III - 28
Doc.DM757-I
Rev.10.60
To Next Page
Loading...
Need help?
General
