30
4.4 Serve as an AP
When you have a smart home gateway which only provides wired internet access, you can set the
router to work in AP mode to provide wireless coverage.
When the router is set to AP mode:
⚫
Every physical port can be used as a LAN port.
⚫
The LAN IP address of the router will be changed. Please log in to web UI of the router by visiting
tendawifi.com.
⚫
Functions, such as bandwidth control and port forwarding will be unavailable. Refer to the web UI
for available functions.
Configuring procedures:
Step 1 Power on the router. Connect a computer to a LAN port of the router, or connect your
smart phone to the WiFi network of the router.
If you have finished the quick setup wizard before, start a web browser and visit tendawifi.com and
skip Step 2.
Step 2 Log in to the web UI of the router.
1. Start a web browser on a device connected to the router and visit tendawifi.com to log in
to the web UI of the router. A computer is used for illustration below.
2. Set Connection Type to Dynamic IP Address, and click OK. You will be directed to the
Status page.