5
Modes
q
Use q to choose modes. Press $ # ! " to choose a
mode, and < to select it. Press - or %s to
return to the Home screen and perform your work using the
chosen mode settings.
Default settings are shown.
DEG RAD Sets the angle mode to degrees or radians.
NORM SCI Sets the numeric notation mode. Numeric
notation modes affect only the display of results, and not the
accuracy of the values stored in the unit, which remain
maximal.
NORM displays results with digits to the left and right of the
decimal, as in 123456.78.
SCI expresses numbers with one digit to the left of the
decimal and the appropriate power of 10, as in
1.2345678x10
5
(which is the same as 123456.78).
Note: C is a shortcut key to enter a number in scientific
notation format. The result displays in the numeric notation
format set in mode.
Note: In some restricted environments (for example, data
editor and the %h menu), the TI-34 MultiView™
calculator may display
E instead of x10
n
.
FLOAT 0123456789 Sets the decimal notation mode.
FLOAT (floating decimal point) displays up to 10 digits,
plus the sign and decimal.
0123456789 (fixed decimal point) specifies the number of
digits (0 through 9) to display to the right of the decimal.
CLASSIC MATHPRINT
CLASSIC mode displays inputs and outputs in a single
line.
To Next Page
Loading...
Need help?
General
