Chapter 19: Communication Link 557
• Variables and applications stored in the user data archive of the sending TI-84 Plus
Silver Edition will be sent to the user data archive of the receiving TI-84 Plus Silver
Edition or TI-84 Plus.
After sending or receiving data, you can repeat the same transmission to additional
TI-84 Plus Silver Edition or TI-84 Plus units—from either the sending unit or the receiving
unit—without having to reselect data to send. The current items remain selected.
However, you cannot repeat transmission if you selected
All+ or All..
To send data to an additional TI-84 Plus Silver Edition or a TI-84 Plus:
1. Use a USB unit-to-unit cable to link two units together.
2. On the sending unit press y 8 and select a data type and items to
SEND.
3. Press ~ on the sending unit to display the
TRANSMIT menu.
4. On the other unit, press y 8 ~ to display the
RECEIVE menu.
5. Press Í on the receiving unit.
6. Press Í on the sending unit. A copy of the selected item(s) is sent to the
receiving unit.
7. Disconnect the link cable only from the receiving unit and connect it to another unit.
8. Press y 8 on the sending unit.
9. Select only the data type. For example, if the unit just sent a list, select
4:LIST.
Note: The item(s) you want to send are pre-selected from the last transmission. Do
not select or deselect any items. If you select or deselect an item, all selections or
deselections from the last transmission are cleared.
10. Press ~ on the sending unit to display the
TRANSMIT menu.
11. On the new receiving unit, press y 8 ~ to display the
RECEIVE menu.
To Next Page
Loading...
Need help?
General
