86
Sending handheld
“<folder>/<filename> transferred as
<folder>/<filename(#).“
This message is displayed at the end of a successful
transfer when the file had to be renamed because
a file already exists on the receiving handheld with
the original name. The transmitted file is renamed
by appending a number to the end of the name.
Rename numbering always begins with (2) and can
increment by one, as needed.
Sending handheld
“<folder>/<filename> transferred as
<folder>/<new filename>.“
This message indicates that a new folder was
created on the receiving handheld to contain the
transmitted document.
Receiving
handheld
“<folder>/<filename(x)> received.“
This message indicates that the receiving handheld
has a document with the same name as the
document being sent.
Receiving
handheld
“<new folder>/<new filename> received.“
This message indicates that a new folder has been
created to contain the transmitted document.
Receiving
handheld
“Transfer failed. Check cable and try
again.“
OK
This message indicates that the cable is not
correctly attached to the receiving handheld’s link
port. Remove the cable then reattach it and try the
transmission again.
Click
OK to cancel the transmission message.
Shown on Message and Description
To Next Page
Loading...
Need help?
General
