OPERATING MANUAL DAF290 TECHNOLOGY
ThyssenKrupp Aufzugswerke GmbH
3.3 Lubrication
The bearings of the DAF290 are provided with life-time lubrication; the drive
therefore requires no further lubrication.
However, if a repair to the bearing is required, the following grease type and
quantities must be added:
AS (output side) 280g
Petamo GHY 441 special grease
Art. no. 270 050 9
Bearing
complete filling
BS 30g
Petamo GHY 441 special grease
Art. no. 270 050 9
Bearing
complete filling
Available from THYSSENKRUPP AUFZUGSWERKE GmbH
Note: THYSSENKRUPP AUFZUGSWERKE GmbH shall not be liable for
losses caused by the use of non-approved lubricants.
3.4 Encoder:
An incremental hollow shaft encoder is installed at the rear rotor shaft end for
controlling the DAF290. The end connection to the control is by means of an
encoder flange socket.
The second encoder is installed on an extended shaft journal of the motor
shaft behind the first encoder. (If retrofitted, the shaft journal must be
replaced.)
Installation instructions, see Appendix
Product has been
replaced
To Next Page
Loading...
Need help?
General
