Before starting engine for the first time
after reassembling engine or off-season
storage, disconnect stop switch lock
and pull the starter handle completely
out approximately 10 times in order to
prime the oil pump.
①
Loosen the air vent screw on the
tank cap.
②
Attach the fuel connector to the
engine connector.
The arrow mark on the primer bulb
should be facing the engine.
③
Feed fuel to the carburetor by
squeezing the primer bulb until it
is firm.
④
After making sure the stop switch
lock has been installed, connect
the hook to a part of the operator's
body.
23
1
2
3
4
5
6
7
8
9
10
11
12
13
Before starting
1. Starting
Note
The engine will not start unless
the switch lock has been properly
connected into the emergency stop
switch.
ENGINE OPERATION
In case engine starts in gear, do not
start cruising. Stop engine immediately
and consult an authorized dealer.
Do not operate the engine with gear
case out of water.
Severe personal injury, or engine
damage will result.
To Next Page
Loading...
Need help?
General
