Coolant Specifications (continued)
• Preferred option: If distilled water is not available, use a pre-mix coolant instead of a
concentrate.
• Minimum requirement: If distilled water and pre-mix coolant are not available, mix
concentrated coolant with clean drinkable water.
Cooling system capacity
Approximately 12.3 L (13 US qt)
Checking the Coolant Level
CAUTION
If the engine has been running, the pressurized, hot coolant can escape, which could
result in minor or moderate injury.
• Do not open the radiator cap when the engine is running.
• Use a rag when opening the radiator cap, and open the cap slowly to allow steam
to escape.
G425390
1. Prepare the machine for maintenance.
2. Open the hood, and wait for the engine to
cool..
3. Carefully remove the radiator cap
.
4. Check the coolant level in the radiator.
Note: The coolant level is correct if it is to the
top of the filler neck
of the radiator.
5. Check the coolant level in the expansion tank.
Note: The coolant level is correct if it is to the
F
ULL mark of the expansion tank.
6. If the coolant is low, add the specified coolant
to the radiator, expansion tank, or both.
7. Install the radiator cap and the expansion-tank
cap
.
8. Close and latch the hood.
3466-702A Page 6–39 Maintenance: Cooling System Maintenance
To Next Page
Loading...
Need help?
General
