Cutting Grass with the Machine (continued)
4. Set the engine-speed switch to HIGH IDLE.
5. Press the PTO switch to the E
NGAGE position.
6. Begin driving the machine into the cutting area and move the lower mow/raise control
lever forward.
Note: The cutting units start running as they lower. The front cutting units are timed to
lower before the rear cutting units
Note: Cutting grass at a rate that loads the engine promotes DPF regeneration.
7. When you complete the mowing pass, move the lever for the mow-speed limiter
backward to lift the cutting units.
8. Perform a tear-shaped turn to quickly line up for your next pass.
Driving the Machine in Transport Mode
G423892
1. Press the PTO switch to the DISENGAGE
position.
2. Move the lower mow/raise control lever
backward to raise the cutting units (transport
position).
G423893
3. Move the lever for the mow-speed limiter
backward to the TRANSPORT position.
4. Press the traction pedal to drive the machine.
3466-702A Page 5–15 Operation: During Operation
To Next Page
Loading...
Need help?
General
