Servicing the Engine Cooling System
1. Prepare the machine for maintenance.
2. Unlatch and open the rear screen.
G425401
Latch keeper
Rear screen latch
3. Clean both sides of the screen.
4. Lift the screen off the hinge pins, and remove the screen from the machine.
5. Open the hood.
6. Clean both sides of the oil cooler/radiator area thoroughly with compressed air. Start
from the front and blow the debris out toward the back. Then clean from the back side
and blow toward the front. Repeat the procedure several times until all chaff and debris
is removed.
IMPORTANT
Cleaning the oil cooler/radiator with water may promote premature corrosion damage
to components and compact debris.
Maintenance: Cooling System Maintenance Page 6–40 3466-702 A
To Next Page
Loading...
Need help?
General
