SAFETY INSTRUCTIONS
MAINTENANCE
12. NEVER open the hydraulic cap until ALL air
pressure has been released.
13. Keep body and hands away from pin hole
leaks or nozzles that eject hydraulic fluid under
pressure. Use paper or cardboard, not hands to
search for leaks.
Hydraulic fluid escaping under pressure can have
sufficient force to penetrate skin and do serious
damage. If fluid is injected into skin it must be
surgically removed within a few hours by a doctor
familiar with this form of injury or gangrene may
result.
14. ALWAYS torque the nut on the wheel motors
to 230 - 250 ft. lbs when servicing.
SAFETY AND INSTRUCTION DECALS
The following safety and instruction decals are installed on the unit. Replace any decals that becomes
damaged or illegible. Part numbers for decals are listed below and in your Parts Catalog. Order
replacements from your Authorized Toro Distributor.
4
LINED UP WITH GATE
CONTROL POINTER
(Part No. 01-506-0210)
NEAR BEARINGS &
GATE CONTROL ARM
(Part No. 58-6520)
ON CHAIN GUARD
(Part No. 01-506-0050)
ON FENDERS & HYD. TANK
(Part No. 75-5190)
EACH SIDE OF HOPPER
(Part No. 01-506-0240)
OVER OIL CAP
(Part No. 01-506-0250)
To Next Page
Loading...
Need help?
General
