Mow/Lift Switch Replacement and Adjustment (Fig. 17)
IMPORTANT: Spool travel for 1, 2 and 3 spools must
be correct before Mow/Lift switch can be adjusted.
(See Rear Camshaft Adjustment in the Adjustments
section of Chapter 4 - Hydraulic System.)
1. Pull connector off switch terminals from end of
mow/lift switch installed in the valve bank bonnet.
2. Loosen jam nut and unscrew switch from valve bank
bonnet.
3. While holding lift pedal in fully depressed position
(valve bank spools fully IN) partially screw new switch
into bonnet.
4. Connect continuity tester on ohm meter across switch
terminals and turn switch in until continuity occurs. Then
rotate switch in 1/2 turn (180) and secure jam nut to 75
in.-lb. (8.5 Nm) against the bonnet.
IMPORTANT: Switch threads will be damaged if the
jam nut is over-tightened.
5. Connect continuity tester or ohm meter to switch
terminals and depress the mow pedal. There should not
be continuity. If there is continuity, repeat step 3. Pro-
ceed to step 6 if there is no continuity.
6. Depress the lift pedal and release it (neutral position).
The switch circuit should have continuity.
7. Fill terminal end of switch and wiring harness cover
with skin-over grease and push connectors onto switch
terminals.
Figure 17
1. Mow/lift switch
Wiring Harness Service
Prevent corrosion of the wiring terminals by applying
skin-over grease to the inside of all harness connectors
whenever the harness is disconnected.
Always disconnect the battery cables, negative (–) ca-
ble first, to prevent possible wiring damage from short-
outs whenever working with the electrical system.
1
Greensmaster
®
3100 Page 5 - 15 Repairs
To Next Page
Loading...
Need help?
General
