Toro Power Max User Manual

4-4 Power Max Service Manual
CONTROLS
5. Lift the metal latch pawl off the hex on the cable
lever. Lift out the latch trigger and spring. Note the
orientation of the pawl to the lever for reassembly
(Fig. 023).
Fig 023 MVC-837X
6. Rotate the cable until the barrel fi tting slides off the
cable lever (Fig. 024).
Fig 024 MVC-554F
Fig 026 MVC-758F
2. Slide the latch trigger over the boss until it is fully
seated, making sure that the stop on the trigger
lever is above the stop on the quick lever, as shown.
While holding the trigger lever in place, rotate the
hooked end of the spring until it hooks under the
front edge of the trigger lever as shown (Fig. 026).
Fig 025 MVC-759F
1. Begin assembly by dropping the latch spring over
the boss. The straight end of the spring should be
down with the hooked end up (Fig. 025).
Reassembly
A
A. Latch trigger

Toro Power Max Specifications

General

Brand	Toro
Model	Power Max
Category	Snow Blower
Language	English