2-1Power Max Service Manual
SPECIFICATIONS
Engine RPM
2-cycle 4,000 +250 -250 RPM
4-cycle 3,300 +150 -150 RPM
Auger
26” 26” (66cm) Wide & 21.5” (54.6cm) High
28” 28” (71cm) Wide & 21.5” (54.6cm) High
Auger Speed 123 RPM @ engine RPM listed above
Impeller 12” Dia. (30.5cm)
Impeller Speed 1228 RPM @ engine RPM listed above
Chute Rotation 200 degrees
Defl ector tilt angle 70 degrees
Tires Semi pneumatic 15x500x6
Pressure 17-20 psi ( 116-137kPa)
Ground speeds
Forward 0.7, 1.1, 1.5, 1.9, 2.3, 2.7 mph
(1.1, 1.8, 2.4, 3.0, 3.7, 4.3 kph)
Reverse 1.0 & 1.6 mph
(1.6 & 2.5 kph)
Height 44.5” (113cm) Approx.
Overall Width 27.5” (69.8cm) and 29.5” (74.9cm)
Length 62” (157cm)
Weight 724= 210 lbs (462kg) 826= 238 lbs (526kg)
828 & 1028= 245 lbs (539kg) 1128= 253 lbs (556kg)
Fuel Capacity
2 cycle engine 1.46 US qts (1.38l)
4 cycle engine 4 US qts (3.8l)
Fuel/oil
2-cycle Fuel Unleaded regular grade gasoline mixed at a ratio of 50:1
2.6 oz. (80ml) oil / 1 US gallon (3.8l) gasoline.
2-cycle Required oil Toro 2 cycle oil or any 2-cycle oil that is NMMA TCW3
(ISO E GD) certifi ed as an acceptable substitute.
4-cycle Fuel Unleaded regular grade gasoline (do not mix with oil).
4-cycle Oil automotive detergent oil with a service classifi cation of
SH or higher Maximum capacity 26 oz. (770ml)
The recommended weight varies with the outside temperature
For Temps Above 32
0
F (0
0
C) use SAE 30W
For Temps Between 0
0
F and
32
0
F ( -18
0
C to 0
0
C)
use SAE 5W30 or SAE 10W
For Temps Below 0
0
F (-18
0
C) use SAE 0W30
Auger Gearbox lubricant* SAE 90 gear oil with a rating of GL5 or higher
*A multi weight may be used such as 85-120 as long as it meets the GL rating. Place the
unit on level ground and fi ll to the fi ll/check plug. Maximum capacity 4 oz (118ml).
To Next Page
Loading...
Need help?
General
