Toro TimeCutter ZR 4200T User Manual

g293796
Figure 7
Performing Daily
Maintenance
Before starting the machine each day , perform the
Each Use/Daily procedures listed in Maintenance
( page 27 ) .
Breaking in a New Machine
New engines take time to develop full power . Mower
decks and drive systems have higher friction when
new , placing additional load on the engine. Allow
40 to 50 hours of break-in time for new machines to
develop full power and best performance.
Using the Safety-Interlock
System
W ARNING
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly , causing personal
injury .
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Understanding the
Safety-Interlock System
The safety-interlock system is designed to prevent the
engine from starting unless:
• The blade-control switch (PT O) is disengaged.
• The motion-control levers are in the P ARK position.
The safety-interlock system also is designed to shut
of f the engine whenever the control levers are out of
the P ARK position and you rise from the seat.
T esting the Safety-Interlock
System
T est the safety-interlock system before you use the
machine each time. If the safety system does not
operate as described below , have an Authorized
Service Dealer repair the safety system immediately .
1. Sit on the seat, move the motion-control levers
in the P ARK position, and move the blade-control
switch to the O N position. T ry starting the
engine; the engine should not crank.
2. Sit on the seat and move the blade-control switch
to the O FF position. Move either motion-control
lever to the center , unlocked position. T ry
starting the engine; the engine should not crank.
Repeat with the other motion-control lever .
3. Sit on the seat, move the blade-control switch
to the O FF position, and lock the motion-control
levers in the P ARK position. Start the engine.
While the engine is running, engage the
blade-control switch, and rise slightly from the
seat; the engine should shut of f.
4. Sit on the seat, move the blade-control switch
to the O FF position, and lock the motion-control
levers in the P ARK position. Start the engine.
While the engine is running, move the
motion-control levers to the center , unlocked
position and rise slightly from the seat; the
engine should shut of f.
13

Toro TimeCutter ZR 4200T Specifications

General

Brand	Toro
Model	TimeCutter ZR 4200T
Category	Lawn Mower
Language	English