Positioning the Seat
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable ( Figure 8 ).
g027249
Figure 8
Adjusting the
Motion-Control Levers
Adjusting the Height
Y ou can adjust the motion-control levers higher or
lower for maximum comfort ( Figure 9 ).
g333847
Figure 9
Adjusting the T ilt
Y ou can adjust the motion-control levers forward or
rearward for your comfort.
1. Loosen the upper bolt holding the control lever
to the control-arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever forward or rearward.
g333846
Figure 10
3. T ighten both bolts to secure the control lever in
the new position.
4. Repeat the adjustment for the other control lever .
Removing the Discharge
Cover for Side-Discharging
1. Park the machine on a level surface, disengage
the blade-control switch (PT O), and move the
motion-control levers outward to the P ARK
position.
2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Release the exible latch from the latch retainer
on the discharge cover and pivot the discharge
cover to the right ( Figure 1 1 ).
14
To Next Page
Loading...
Need help?
General
