Stopping the Machine
If you must stop the forward motion of the machine
while mowing, a clump of grass clippings may
drop onto your lawn. T o avoid this, move onto a
previously cut area with the blades engaged or you
can disengage the mower deck while moving forward.
Keeping the Underside of the
Mower Deck Clean
Clean clippings and dirt from the underside of the
mower deck after each use. If grass and dirt build up
inside the mower deck, cutting quality will eventually
become unsatisfactory .
Maintaining the Blade(s)
Maintain a sharp blade throughout the cutting season
because a sharp blade cuts cleanly without tearing or
shredding the grass blades. T earing and shredding
turns grass brown at the edges, which slows growth
and increases the chance of disease. Check the
mower blades after each use for sharpness, and
for any wear or damage. File down any nicks and
sharpen the blades as necessary . If a blade is
damaged or worn, replace it immediately with a
genuine T oro replacement blade. Refer to Servicing
the Cutting Blades ( page 41 ) .
After Operation
After Operation Safety
General Safety
• Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operator ’ s position. Allow the machine to cool
before servicing, adjusting, fueling, cleaning, or
storing it.
• Clean grass and debris from the cutting unit,
muf er , drives, grass catcher , and engine
compartment to help prevent res. Clean up oil or
fuel spills.
• Remove the key before storing or transporting the
machine.
Cleaning the Machine
Service Interval : After each use
Important: Y ou can wash the machine with a mild
detergent and water . Do not pressure wash the
machine. A void excessive use of water , especially
near the control panel, under the seat, around the
engine, hydraulic pumps, and motors.
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P ARK
position.
2. Shut of f the engine and wait for all moving parts
to stop before leaving the operating position.
3. Clean grass and debris from cutting unit, muf er ,
drives, grass catcher , and engine.
Note: Refer to W ashing the Underside of the
Mower Deck ( page 48 ) for information on using
the deck-washout tting.
Pushing the Machine by
Hand
This machine has an electric-brake mechanism,
and to push the machine, the key must be in the
RUN position. The battery needs to be charged and
functioning to disengage the electric brake.
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P ARK
position.
2. Shut of f the engine and wait for all moving parts
to stop before leaving the operating position.
3. Locate the bypass levers on the frame on both
sides of the engine.
24
To Next Page
Loading...
Need help?
General
