6
STEP 3 - Set Station Run Time
The length of time a station operates during a watering cycle is called Run
Time. Each station can have its run time set in one of two modes: Minutes or
Hours. Minutes mode provides a station run time from 1 to 90 minutes (in 1
minute increments). Generally, a run time under 90 minutes is more than
adequate for most lawn and shrub sprinkler applications. However, drip
irrigation emitters often require a run time of several hours in order to supply
the proper amount of water. Selecting Hours mode enables run time to be set
from
10 minutes to 9 hours (in 10 minute increments) for any drip watering
requirements. Use the following procedure to set a run time for each station.
❑ Turn desired Station Dial slowly
until display shows run time.
Note: Run time will be displayed
for 5 seconds after dial is turned.
❑ Turn Station Dial in either direction
to display exact run time. (
Example
shown: 15 minutes).
❑ Repeat procedure with each station
dial to set a run time for each station.
Note: Turning Station Dial past 90
minute mark will manually
activate station. If this occurs,
simply turn dial counterclockwise
to 0 (OFF) and reset to desired run
time.
❑ Set all unused stations to 0 (OFF).
(continued)
To Next Page
Loading...
Need help?
General
