8-6
User's Manual
OPTIONAL DEVICES
Removing an SD card
To remove an SD card, follow the steps below.
1. a. In Windows XP, open the Safety Remove Hardware icon on the
system tray and disable the SD card.
b. In Windows 2000, open the Unplug or Eject Hardware icon on the
system tray and disable the SD card.
2. Push in the card and release it to pop the card out slightly.
3. Grasp the card and remove it.
Figure 8-6 Removing an SD card
CAUTION: Make sure the SD card indicator is out before you remove
the card or turn off the computer’s power. If you remove the card or turn
off the power while the computer is accessing the card you may lose data
or damage the card.
Memory expansion
You can install additional memory in the computer’s memory module to increase the
amount of RAM.
CAUTION: Use only memory modules approved by TOSHIBA.
SD CARD
SD CARD INDICATOR
To Next Page
Loading...
Need help?
General