5-5
THE KEYBOARD
Power save mode: Pressing Fn + F2 changes the power save mode.
If you press Fn + F2, the Power Save Mode is displayed in a dialog box. Continue
holding down Fn and press F2 again to change the setting. You can also change
this setting through the Plugged in or Running on batteries item of the Power
Saver Properties window in Power Saver.
Standby: When you press Fn + F3, the computer can enter Standby. To avoid
entering Standby unexpectedly, a dialog box appears for verification. However, if
you check the checkbox in the dialog box, it will not appear from the next time.
Hibernation: When you press Fn + F4, the computer can enter Hibernation. To
avoid entering Hibernation unexpectedly, a dialog box appears for verification.
However, if you check the checkbox in the dialog box, it will not appear from the next
time.
Display selection: Press Fn + F5 to change the active display device. When you
press these hot keys a dialog box appears. Only selectable devices will be displayed.
Hold down Fn and press F5 again to change the device. When you release Fn and
F5, the selected device will change. If you hold down the keys for three seconds the
selection will return to LCD.
Soft keys: Fn key combinations
To Next Page
Loading...
Need help?
General