26
CONTROLS AND FEATURES
English
The Base Colour Adjustment feature allows the adjustment of
individual colours to suit personal preference. This can be useful
when using an external source.
a In the Advanced Picture Settings menu, press B or
b to select Base Colour Adjustment and press OK.
b Press B or b to select an option and press c to move
to the adjustment window.
c Press C or c to select Hue, Saturation or Brightness
and press
B or b to adjust the settings as required.
d Press BACK to return to the previous menu.
To return to the factory settings, select Reset and
press OK.
Colour Temperature increases the ‘warmth’ or ‘coolness’ of the
picture by increasing the red or blue tint.
a In the Advanced Picture Settings menu, press B or
b to select Colour Temperature and press OK.
b Press B or b to select Colour Temperature and
press
C or c to select Cool, Normal or Warm to suit
your preference.
c Press B or b to select Red Level, Green Level or
Blue Level and press
C or c to adjust the level.
NOTE: To return the adjustments to the factory defaults,
select Reset and press OK.
When the Auto Brightness Sensor is activated, it will
automatically optimise the backlighting levels to suit ambient
light conditions.
a In the Advanced Picture Settings menu, press B or
b to select Auto Brightness Sensor.
b Press C or c to select On or Off.
When Active Backlight Control is activated, it will
automatically optimize the backlighting levels for dark scenes.
a In the Advanced Picture Settings menu, press B or
b to select Active Backlight Control.
b Press C or c to select On or Off.
Black/White Level increases the strength of dark areas of the
picture to improve the definition.
a In the Advanced Picture Settings menu, press B or
b to select Black/White Level.
b Press C or c to select High, Middle, Low or Off.
When watching a DVD, the compression may cause some words
or picture elements to become distorted or pixelated.
Using the MPEG NR feature reduces this effect by smoothing out
the edges.
a In the Advanced Picture Settings menu, press B or
b to select Noise Reduction and press OK.
b Press b to select MPEG NR.
c Press C or c to select Low, Middle, High or Off to suit
your preference.
DNR allows you to ‘soften’ the screen representation of a weak
signal to reduce the noise effect.
a Select DNR from the Noise Reduction menu.
b Press C or c to select Low, Middle, High, Auto or Off.
The differences may not always be noticeable (for the
best result use lower settings as picture quality can be
lost if the setting is too high).
Base Colour Adjustment
Colour Temperature
To Next Page
Loading...
Need help?
General
