71
EN
Introduction Connections Playback Editing OthersFunction SetupRecording VHS Functions
Basic Setup /
TV View Operation
Press [REC I] repeatedly until the desired
recording time (30 minutes to 8 hours) appears
on the TV screen.
One-touch Timer Recording will start.
• When the unit reaches the specified time, it will be turned off
automatically.
• To change the recording length during One-touch Timer
Recording, press [REC I] repeatedly until desired length
appears.
• To cancel One-touch Timer Recording within the specified
time, press [STOP C].
Note
• The remaining recording time will appear on the TV screen
during One-touch Timer Recording. Press [DISPLAY] to see
it on the TV screen.
• If VHS One-touch Timer Recording is completed during DVD
playback or recording, the VHS will be in stop mode and the
DVD keeps the current mode.
• You cannot use the pause function during One-touch Timer
Recording.
• When One-touch Timer Recording is finished and the power
is turned off, the unit will switch to the timer-standby mode
automatically if a timer recording has been programmed.
Press [TIMER SET] to cancel the timer-standby mode in
order to use the unit continuously.
5 Press [STOP C] when the recording is
completed.
To prevent accidental recording on a recorded cassette,
remove its record tab. To record on it later, cover the hole with
cellophane tape.
This function helps you to dub the contents in the DVC (digital
video camcorder) to VHS.
• Insert a recordable videotape.
• Make sure your DVC is in video mode.
1 Press [INPUT SELECT F] repeatedly to select
the external input channel, then press
[PROG. G\H] repeatedly to select DV(AV3).
2 Select the recording mode using [REC MODE].
(See page 70.)
3 Stop or pause the DVC where you want to start
dubbing.
4 Play back the DVC.
5 Press [REC I].
The dubbing will start.
Note
• Dubbing will start from where the tape is stopped.
Search
1 Press [SEARCH] so that the index search menu
appears.
2 Enter the number of recordings you want to
skip using [the Number buttons] within 30
seconds.
3 Press [FWD D] or [REV E] to start index
search.
If you want to go in the forward direction, press
[FWD D].
If you want to go in the reverse direction, press [REV E].
After index search, the VHS will play back the tape
automatically.
Note
• This function is not available during recording.
• Every time a tape is recorded, an index mark is written on
the tape.
• You can make the index mark up to 20.
One-touch Timer Recording:
Prevent accidental erasure
0:30
8:00 7:30
1:00
Normal Recording
Record tab
DVC to VHS Dubbing
Preparing for DV dubbing (DVC to VHS):
Index Search
VHS
To Next Page
Loading...
Need help?
General
