Using Bypass Tray 55
Bypass copying on standard size paper
Standard size paper can be used for bypass copying. In this section, the procedure is described
with A4 size thick paper (90 g/m
2
) placed on the bypass tray as an example.
Register the size of the paper into the equipment in advance.
P.51 “Preparation - Registering paper size placed on bypass tray”
1
Place paper straight on the bypass tray face down. Then align the
side guides to the paper length while holding (A).
y Be sure that the stack height of paper does not exceed the indicators of the side
guides.
y Fan the stack of paper well before placing it on the bypass tray.
y Do not push the paper forcibly into the entrance of the bypass feeder. This could
cause a paper misfeed.
When you place paper of a larger size, pull out the paper holder before you start bypass
copying.
A
To Next Page
Loading...
Need help?
General
