Toshiba Satellite A50 User Manual

6-14 User’s Manual
Power and Power-Up Modes
Installing the battery pack
To install a battery, follow the steps below.
1. Turn the computer’s power off.
2. Disconnect all cables connected to the computer.
3. Insert the battery pack.
4. Secure the battery release latch(1). Check the battery release latch(1)
was changed to the lock position. (to the direction of the right)
Figure 6-4 Securing the battery pack
■ The battery pack is a lithium ion battery, which can explode if not
properly replaced, used, handled or disposed of. Dispose of the battery
as required by local ordinances or regulations. Use only batteries
recommended by TOSHIBA as replacements.
■ Do not touch the latch while holding the computer. Or you may get
injured by the dropped battery by unintentional release of the latch.
Battery pack
Battery release latch(1)

Toshiba Satellite A50 Specifications

General

Processor	Intel Pentium M or Intel Celeron M
RAM	256MB - 2GB DDR SDRAM
Storage	40GB HDD
Display	15.0" XGA (1024x768)
Operating System	Windows XP Home/Professional
Optical Drive	DVD-ROM
Battery	Li-Ion
Networking	10/100 Ethernet, 56k modem, optional Wi-Fi
Ports	3 x USB 2.0, 1 x VGA
Audio	Built-in stereo speakers