Gap between the Main Unit and the Toilet Lid (Approximately once a month)
The toilet lid can be removed for thorough cleaning.
Soft cloth soaked in water Toilet paper, etc.
(May cause damage.)
1
Switch the breaker on the
distribution board to OFF.
Removing and Reinstalling
Ⓓ
Ⓔ
Pin
Hinge
Hinge
Tab
Ⓑ
Ⓒ
Ⓐ
Hold with
both hands
2
Remove the main unit.
(Pages 32, 33)
3
Remove the toilet lid.
Slightly tilt the toilet lid to the front.
↓
Ⓐ
: Pull the left side outward.
↓
Ⓑ
:
Disconnect the hinge from the tab and pull up.
↓
Ⓒ
: Disconnect the right side.
4
Wipe with a soft cloth that
has been soaked in water
and wrung-out thoroughly.
5
Reinstall the toilet lid.
Ⓓ
:
Join the pin and the hinge on the right side.
↓
Slightly tilt the toilet lid to the front.
↓
Ⓐ
: While pulling out the left side,
↓
Ⓔ
:
Mount by joining the hinge with the tab.
* Be careful not to pinch your ngers.
6
Mount the main unit.
(Pages 32, 33)
7
Switch the breaker on the
distribution board to ON.
x
The "Power" LED lights up.
8
Open and close the toilet lid
to check the reinstallation.
Maintenance
Gap between the Main Unit and the Toilet Lid
34
To Next Page
Loading...
Need help?
General