What to Do?
1
Use a bucket to ush water.
2
If the water level is low after
ushing, add more water.
• Prevents odors.
Attention!
• Before starting work, set "AUTO FLUSH" to "OFF"
(only when "FLUSH" button is located on the top side of the remote control). (Page 38)
• When the water supply is restored, be sure to perform a full ush.
(To prevent waste from remaining in the drain pipe.)
■
Replacing the batteries
1
Switch the breaker on the distribution board to OFF.
2
Remove the remote control from the hanger.
(Page 14)
<Power>
3
Open the battery cover and replace two AA batteries.
(Page 14)
• The low battery warning mark goes off.
4
Mount the remote control in the hanger.
5
Switch the breaker on the distribution board to ON.
• The "Power" LED lights up.
Attention!
• "ON" and "OFF" settings of the functions such as the energy saver function may be canceled when the batteries
are replaced.
Set them again.
If the water does not ow due to a water service interruption
If you cannot operate with the remote control
■
If the low battery warning mark " " on the
display screen on the back of the remote control
lights up, please replace the batteries.
0(18
0$18$/
&/($1,1*
Low battery
warning mark
If the water does not ow due to a water service interruption
If you cannot operate with the remote control
Newspaper, dustcloth, etc.
Large bucket
Pour strongly, aiming
at the center of the
bowl unit.
56
To Next Page
Loading...
Need help?
General