If the toilet is in a location you will not visit for a long time, drain the water.
(The water in the tank may cause malfunctions or become contaminated and cause skin irritation or other problems.)
How to drain the water
1
Drain the water from the toilet tank.
(Page 57 Step
1
,
2
)
2
Press
"Wand CLEAN" button.
• Open the wand cover.
(Release the pressure from the water supply
pipe.)
3
Switch the breaker on the
distribution board to OFF.
4
Drain the pipe.
(Page 57 Step
5
)
5
Pull out the water drain lever.
• Water comes out from around the wand
(about 20 seconds)
Water drain lever
6
Release your hand to return the
water drain lever to its original
position.
■
If water may get frozen
• Add antifreeze solution in the water in the bowl to
prevent freezing.
(The antifreeze solution should not be ushed out.
Collect it before using the toilet and dispose of it.)
■
To use the product again
• The water needs to be resupplied. (See below)
Resupplying the Water
1
Open the shutoff valve. (Page 15)
• Check that water is not leaking from a pipe or the main unit.
2
If the power is not turned ON,
switch the breaker on the distribution board to ON.
• The "Power" LED lights up.
3
Discharge water from the wand.
(1) Pressing down the left side of the toilet seat,
(2)
Press "Rear cleansing" button on the remote control to
discharge water from the wand.
• Catch the water in a paper cup or other receptacle.
(3)
Press "Stopping" button.
■
If the remaining water has frozen and no water comes out
• Heat the inside of the bathroom, and warm the water supply hose and shutoff valve using a cloth
soaked in warm water.
Soft cloth soaked in water
(to prevent scratching)
Paper cup
What to Do?
Long Periods of Disuse
58
To Next Page
Loading...
Need help?
General