B07976
A56700
SST
A09449
SST
A09451
A09555
Measuring Point
16 mm (0.63 in.)
14−10
−ENGINE MECHANICAL PARTIAL ENGINE ASSY (1CD−FTV)(From September,
2003)
1CD−FTV ENGINE REPAIR MANUAL (RM1046E)
28. REMOVE CRANKSHAFT SEAL
(a) Using a screwdriver and hammer, tap out the oil seal.
29. INSTALL CRANKSHAFT SEAL
(a) Using SST and a hammer, tap in a new oil seal until its sur-
face is flush with the oil pump edge.
SST 09316−60011 (09316−00011, 09316−00021)
(b) Apply multipurpose grease to a new oil seal lip.
NOTICE:
Keep the lip free of foreign objects.
30. REMOVE ENGINE REAR OIL SEAL
(a) Using a screwdriver and hammer, tap out the oil seal.
31. INSTALL ENGINE REAR OIL SEAL
(a) Using SST and a hammer, tap in a new oil seal until its sur-
face is flush with the rear oil seal retainer edge.
SST 09223−15030, 09950−70010 (09951−07100)
(b) Apply multipurpose grease to a new oil seal lip.
NOTICE:
Keep the lip free of foreign objects.
32. INSPECT CYLINDER HEAD SET BOLT
(a) Using vernier calipers, measure the tension portion diam-
eter of the bolt.
Standard outside diameter:
10.40 to 11.00 mm (0.4094 to 0.4331 in.)
If the diameter is less than minimum, replace the bolt.
ProCarManuals.com
To Next Page
Loading...
Need help?
General
