A87939
6mm
Hexagon
Wrench
A85943
A56044
A56045
A09510
Groove
14−58
−ENGINE MECHANICAL CYLINDER BLOCK ASSY (1CD−FTV)(From September,
2003)
1CD−FTV ENGINE REPAIR MANUAL (RM1046E)
25. INSTALL CYLINDER BLOCK OIL ORIFICE
(a) Using a hexagon wrench (6 mm), install the oil orifice.
Torque: 9.0 N×m (92 kgf×cm, 80 in.×lbf)
26. INSTALL SUB−ASSY OIL NOZZLE NO.1
(a) Install the 4 oil nozzles with the 4 bolts.
Torque: 7.4 N×m (75 kgf×cm, 65 in.×lbf)
27. INSTALL CRANKSHAFT
(a) Install the bearing on the cylinder block and bearing cap.
HINT:
Each upper bearing has an oil groove and oil hole and each low-
er bearing does not.
(1) Align the bearing claw with the claw groove of the
cylinder block, then push in the 5 upper bearings.
(2) Align the bearing claw with the claw groove of the
main bearing cap, then push in the 5 lower bear-
ings.
(b) Install the 2 thrust washers under the No. 3 journal posi-
tion of the cylinder block with the oil grooves facing out-
ward.
ProCarManuals.com
To Next Page
Loading...
Need help?
General
