CANNOT ACCELERATE SMOOTHLY (INCLUDING HESITATION)
I
Classification
I
Main places for inspection and adjustment
I
I
1.
Accelerator pedal and link
[Point
I]
I
Fuel
2. Governor
I
13.
Accelerator pump
I
1.
Spark plugs
2.
Ignition timing
3,
Ignition circuit
4.
Vacuum advancer
[Point
21
Ignition
15.
Vacuum hose
1
6.
Vacuum controller
7.
Breaker plate
8.
Governor controller
[Point 31
9.
Air governor
[Point
41
Compression
I
1.
Intake and exhaust valve contact
12. Piston rings
13.
Piston
I
4.
Cylinder
[Point
I]
Adjust the accelerator pedal and link system
The opening of the throttle valve depends on the adjustment of the
accelerator pedal height and the link wire. Check that the throttle
valve becomes fully open when the accelerator pedal is fully
depressed.
[Point
21
Check vacuum advancer function
1.
Connect a timing light with the engine running. Inspect to see
that the degree of advance is reduced when the vacuum hose
is disconnected from the distributor, and that it returns to its
original position when the vacuum hose is reconnected.
Note:
If
this inspection is as it should be, omit the inspection in
2.
To Next Page
Need help?
General
