I
Delivery
pipe
FUEL PRESSURE REGULATOR
Inspection
Caution:
Put waste cloth in order' to prevent the fuel from
splashing.
Do not allow any fire to come close during the operation.
1.
Remove the negative terminal of the battery.
2.
Eliminate the fuel pressure. (See P5-7)
3.
Install the fuel pressure indicator between the fuel filter and the
delivery pipe via
SST.
SST 09268-76007-71
(09268-4 1 047)
4.
Turn the ignition key switch on to activate the fuel pump, and
measure the fuel pressure at that moment.
Standard: 284
5
kPa
(2.9
f
0.1 kgflcm2) [41.2
&
1.4 psi]
Note:
The above standard is applied when the vacuum port of the
pressure regulator is an atmospheric discharge.
To Next Page
Loading...
Need help?
General
