ower valve rod
Good
No good
Hot idle compensator inspection
Use fingers to move the valve of the hot idle compensator, and
check that it moves lightly.
Solenoid valve function inspection
(1) Connect the solenoid valve to the battery and set it to
ON
and OFF. Check that a clicking sound is heard.
(2)
Replace the valve if it does not function correctly.
Accelerator pump diaphragm inspection
(1) Check the diaphragm for any damage.
(2)
Push the plunger rod with a finger. Check that it moves
smoothly.
Power valve sliding inspection
Push the power valve rod lightly with a finger, and check that it
slides smoothly.
Idle adjusting screw inspection
Check that the tapered portion of the idle adjusting screw is not
stepped and that the threaded portion is not damaged.
Throttle valve and shaft inspection
Operate the throttle lever, and check that the throttle shaft
slides smoothly.
To Next Page
Loading...
Need help?
General
