123
Maintenance and Adjustment
Turn Signal Lights
Bulb Replacement
1. Turn signal lens
2. Securing screw
The lens on each turn signal light is held in
place by a securing screw located in the lens
of the light.
Loosen the screw and remove the lens to
gain access to the bulb for replacement.
License Plate Light
Bulb Replacement
Remove the front panel from the fuel tank.
Disconnect the battery, negative (black) lead
first.
Remove the fasteners for both rear indicators.
1. Fastener, left hand side shown
2. License plate bracket
Carefully raise the license plate bracket to
gain access to the locknut.
Counter-hold the locknut to prevent it from
turning and remove the license plate light
fastener. Collect the locknut.
Detach the light from the bracket. It is not
necessary to disconnect the electrical
connectors.
Do not pull the license plate bracket more
than is necessary to access the light's inside
nut. Damage to the bracket will result from
pulling it too far.
To Next Page
Loading...
Need help?
General
