25
General Information
Instantaneous Fuel Consumption
An indication of the fuel consumption at an
instant in time.
Average Speed
The average speed is calculated from when
the trip computer was last reset. After being
reset the display will show dashes until
1 mile/km has been covered.
Trip Meter Reset
To reset either of the trip meters, select and
display the trip meter to be zeroed then press
button 'B' for 2 seconds. After 2 seconds, the
trip meter on display will reset to zero.
Note:
• When a trip meter is reset to zero,
the trip time, average fuel
consumption and average speed
will also be set to zero for that trip
meter.
To exit the trip meter, press and release
button 'A' until the desired display is visible.
Odometer
When the ignition is switched on, the
odometer will be displayed for 3 seconds
then the last selected trip meter will be
shown.
The odometer shows the total distance that
the motorcycle has travelled.
To access the odometer, with the motorcycle
stationary and in neutral press and release
button 'A' until set up is visible in the display
screen then press button 'B'. Press and
release button 'A' until odometer is visible.
To exit odometer, press and release
button 'A' until r
Eturn is visible then press
button 'B'. Trip 1 will be visible in the display
screen.
Do not attempt to switch between
odometer and trip meter display modes or
reset the trip meter with the motorcycle in
motion as this may lead to loss of
motorcycle control and an accident.
To Next Page
Loading...
Need help?
General
