94
Maintenance and Adjustment
Steering/Wheel Bearings
Steering Inspection
Lubricate and inspect the condition of the
steering head (steering) bearings in
accordance with scheduled maintenance
requirements.
Note:
• Always inspect the wheel bearings
at the same time as the steering
bearings.
Inspecting the Steering (Steering
head) Bearings for Free Play
Position the motorcycle on level ground, in an
upright position.
Raise the front wheel above the ground and
support the motorcycle.
Standing at the front of the motorcycle, hold
the lower end of the front forks and try to
move them forward and backward.
If any free play can be detected in the
steering (steering head) bearings, ask your
authorized Triumph dealer to inspect and
rectify any faults before riding.
Remove the support and place the
motorcycle on the side stand.
To prevent risk of injury from the
motorcycle falling during the inspection,
ensure that the motorcycle is stabilized and
secured on a suitable support. Do not
exert extreme force against each wheel or
rock each wheel vigorously as this may
cause the motorcycle to become unstable
and cause injury by falling from its support.
Ensure that the position of the support
block will not cause damage to the sump.
Riding the motorcycle with incorrectly
adjusted or defective steering (steering
head) bearings is dangerous and may
cause loss of motorcycle control and an
accident.
To Next Page
Loading...
Need help?
General
